- Член од
- 9 јануари 2006
- Мислења
- 5.761
- Поени од реакции
- 7.690
Stvarno neznam druze koja e razlikata, izmenuvacite ocigledno so razvoj na tehnologija gi menuvaat so testiranje, tendencija e da se so pomal Fi a pak da dadat ista snaga a da zastedat na bakar.Kaj ovoj model -inace HansolПрегледај го приврзокот 131468
gledam kaj "Pipe diameter" vika Ф7 i kaj "Rows-fin Gap" stoi 2.5 so 1.5, "Coil lenght" e 733.5x57x550mm.
Modelot koj go zema DarkoGv i podatocite sto on gi postavi, a koi veruvam mu gi dale od greemak, stoi slednovo
Прегледај го приврзокот 131469
"Pipe diameter" Ф9.52, "Rows-fin Gap" 2 so 1.4, "Coil lenght" 803x44x559
Ocigledno kaj ovie dva modela (razlika vo imeto B i D na kraj od oznakite) ova e edinstvenata razlika.
Kakva uloga igra ova? E nekoja kombinacija podobra ili zanemarlivo e?
Kaj tebe ako e 1B ide so Fi=7 ama imas 2ipol reda izmenuvac nasprema ovoj najnoviot od samo 2 reda a podebel Fi...bitno e deka razlika vo Btu nema 1700/1760btu kaj 1B/1D
Tvojata e so 1B na krajot proizvedena e koja godina 2012 , 2013 ?[DOUBLEPOST=1445638489][/DOUBLEPOST]
Pa i nije bas tacno to sto kazes.Grejac o kome ti pricas i mnogi drugi napravise nauku oko toga, NE IDE na kompresor, NE POSTAVLJA SE NA KOMPRESOR.
Taj se grejac zove Crankcase heater(onaj na tacni je Chassis Heater), cak i wiki ima clanak o njemu ali meni se vise dopada ovaj text:
One thing that may be confusing to people is why some compressor units will have crankcase heaters installed on or in the compressor and other compressors may not have any installed. It helps to understand the overall application of the equipment and it's location.
Compressors installed outdoors in cold applications make this a mandatory requirement. During the off-cycle the compressor can cool down and allow the oil to dissolve in the refrigerant. When the compressor starts up on the next run cycle the diluted oil thins out (lower viscosity) and can wreck a compressor.
In general practice it is always a good idea to have a crankcase heater installed on the compressor. Usually when you do not see a heater installed on the compressor it is either due to:
1. Someone did not understand why they are required, or
2. Someone tried to save money!

Inace izgleda vaka
Последно уредено:

